One-step method for preparing the experimental pure state in nuclear magnetic resonance

Quantum computing is an emerging and promising research field in modern quantum physics and is committed to accelerating traditional calculation processes using the principle of quantum mechanics[1,2].Several computation models have been proposed,including the circuit model[3],topologic quantum computation[4],adiabatic quantum computing[5],and duality quantum computing[6-8].Universal quantum computation generally includes a system initialization,evolutionary control,and a final-state readout[9],where the preparation of the initial state is a key step in the entire process.     

Identification and quantification of main flavonoids in the leaves of Bambusa multiplex cv. Fernleaf

Abstract

The chemical profile of Bambusa multiplex cv. Fernleaf (B. multiplex) leaves was analysed by UPLC-DAD-Q-TOF-MS. Twelve compounds were identified and C-glycosyl flavonoids, including vitexin, isovitexin, isoorientin and its derivatives, are the main constitutes of the plant. Besides, a HPLC method for isoorientin quantification was developed. The RSD of retention time and peak area were 0.05% and 2.04% for six times analysis of isoorientin with concentration of 20?μg/mL. The recovery of isoorientin in real sample was 99.2%. The general trend of isoorientin content in B. multiplex leaves was that it steady increased from Jan. to May, and then quickly decreased. The maximum was found on May with value of 4.7?mg/g. The lowest level of isoorientin was found during Aug. to Nov. with value of about 1.66?mg/g. In different seasons, isoorientin is always the most dominant flavonoid which was accounted for about 50% of total flavonoids in the sample.     

基于非线性光纤环形镜的少模脉冲幅度调制再生器

随着网络带宽需求的快速增加,波分复用系统的容量已接近非线性香农极限.为了适应未来网络的发展,空分复用技术引起了越来越多的关注.本文首次提出基于少模非线性光纤环形镜(FM-NOLM)的脉冲幅度调制(PAM)全光再生器,描述了其工作原理和具体设计过程.采用COMSOL软件对组成FM-NOLM的硫化物高非线性光纤进行了模式特性仿真.以LP01,LP11,LP21三个光纤模式为例,确定了再生器的参数,计算出每个模式的功率转移函数曲线.仿真分析了该少模PAM-4全光再生器的噪声抑制(NRR)性能,并与单模情形进行了比较.研究表明,1)对于每个空间模式的PAM信号,所有再生电平具有一致的功率转移性能;2)当输入信噪比(SNR)约大于20 dB时,三种模式的噪声抑制比均可超过3 dB,并随着输入信噪比线性增加,其斜率约为1.2;3)在相同输入SNR条件下,三种模式的噪声抑制比相差不大,不超过1.1 dB.为了说明再生器的再生性能,当输入SNR为25 dB时,我们还给出了再生前后PAM-4信号的功率分布直方图.与现有的再生方案相比,本文方案的均匀多电平再生转移性能,使其更适合高频谱效率的长距空分复用系统和任意电平数的PAM信号再生.此外,该方案也能够扩展到波长域,有效提高光通信系统的传输容量.     

Bi-2223/Ag异质结的光生电压效应研究

在50 ～ 340 K不同温度下,利用紫色激光(λ=405 nm)对银/铋锶钙铜氧2223异质结界面进行辐照,观测到明显的光生电压效应,发现光生电压的极性分别在超导转变温度TC与320 K附近发生了反转,排除了激光产生的热电势是产生光生电压的原因,分析表明银/铋锶钙铜氧2223异质结界面处存在内建电场:光生电压由异质结界面处的内建电场分离光生电子-空穴对产生的.超导转变温度TC之下以及320 K以上,内建电场方向从超导体指向金属电极;超导转变温度TC与反向温度320 K之间,内建电场从金属指向超导体.     

GZO/Al复合背电极对非晶硅太阳能电池的影响

随着能源紧缺与环境污染问题的日益严重,太阳能的开发利用越来越受到重视,其中非晶硅薄膜太阳能电池由于其制备工艺简单、价格低廉等优点被广泛地研究.为了使非晶硅薄膜太阳能电池得到更好地利用,提高其转换效率和稳定性显得尤为重要.引入复合背电极是提高非晶硅太阳能电池性能的有效手段,其中对GZO/Al复合背电极的研究还未见报道.在该工作中,利用磁控溅射法在非晶硅电池上制备了GZO/Al复合背电极,研究了复合背电极的制备条件及其对非晶硅太阳能电池性能的影响.结果显示,当GZO层的溅射功率为90 W、Al层的溅射功率为90 W时,具有复合背电极的太阳能电池表现出较好的光电转换性能,其短路电流(ISC)、开路电压(VOC)、填充因子(FF)和电池的光电转换效率(η)分别为8.92 mA、1.55 V、54.48;和7.53;.相较于单层Al背电极的太阳能电池,其光电转换效率大幅提高了47.6;(相对效率).     

玻璃料对铜基金属结合剂性能及结构的影响

采用粉末冶金法向铜基金属结合剂中引入玻璃料,结合材料电子万能试验机、洛氏硬度仪、SEM等检测方法,研究了玻璃料加入对铜基金属结合剂及金刚石磨具的影响.结果表明,随着玻璃料含量的增加,铜基结合剂的抗折强度和抗冲击强度呈下降的趋势,其硬度呈逐渐上升趋势,硬脆相的引入提高了铜基金属结合剂的自锐性;玻璃相和金属相之间结合紧密,两相之间化学元素在界面处发生相互扩散;玻璃料的加入使结合剂对磨料的包裹更加紧密,大大提高了结合剂对金刚石的把持力,有利于增加金刚石磨具寿命及加工效率.     

零维到三维结构中三核铜自旋阻挫簇单元的磁构关系和反对称交换

量子自旋液体是最近几年刚被人们证实除铁磁体、反铁磁体之外的第三种磁性类型,因其有望解释高温超导的运行机制、改变计算机硬盘信息存储方式而在物理、材料等领域备受关注。自旋阻挫作为量子自旋液体的最小单元可能是解开量子自旋液体诸多问题的钥匙,所以在磁学、电学研究领域再一次成为人们研究的热点。基于文献报道的三核铜配合物[Cu3(μ3-OH)(μ-OPz)3(NO3)2(H2O)2]·CH3OH(1),我们合成了三维金属有机框架配合物{[Ag(HOPz)Cu3(μ3-OH)(NO3)3(OPz)2Ag(NO3)]·6H2O}n(2)(HOPz=甲基(2-吡嗪基)酮肟),并从自旋阻挫的角度对二者磁性质进行对比和详细分析。磁化率数据表明自旋间有很强的反铁磁相互作用和反对称交换。通过包含各向同性和反对称交换的哈密顿算符对两者磁学数据进行拟合并研究其磁构关系,所获最佳拟合参数为:配合物1:Jav=-426 cm^-1,g⊥=1.83,g∥=2.00;配合物2:Jav=-401 cm^-1,g⊥=1.85,g∥=2.00。     

Facile synthesis of linear–hyperbranched polyphosphoesters via one‐pot tandem ROMP and ADMET polymerization and their transformation to architecturally defined nanoparticles

A convenient one‐pot synthesis of linear–hyperbranched polyphosphoesters (l–HBPPEs) was accomplished by a tandem ring‐opening metathesis polymerization (ROMP) and acyclic diene metathesis (ADMET) polymerization procedure. A linear monotelechelic poly(norbornene) with a terminal acrylate and many pendent thiol groups is first prepared through adding an internal cis‐olefin terminating agent to the reaction mixture immediately after the completion of the living ROMP, and then utilized as a macromolecular chain stopper in subsequent ADMET polymerization of a phosphoester functional AB₂ monomer, yielding l–HBPPEs as the reaction time prolonged. These l–HBPPEs bearing lots of pendent thiol groups in linear poly(norbornene) and peripheral acrylate groups in HBPPE could be self‐crosslinked in ultradilute solution through thiol‐Michael addition click reaction between acrylate and thiol to give single‐molecule nanoparticles with comparatively uniform size. This facile approach can be extended toward the fabrication of novel nanomaterials with sophisticated structures and tunable multifunctionalities. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 964–972